How To Install And Use The loading arm Correctly?

Crane tubes are widely used in many industries, and for us, crane tubes are a good helper for guiding liquid and gas. At the beginning, the crane tube was only limited to application in the chemical industry, but with the improvement of the crane tube and the progress of society, the performance of the crane tube is also increasing, and its characteristics have been recognized by many industries, occupying an important position in various fields. Although the crane tube has many benefits, we also need to use it correctly and reasonably. If the crane tube is not installed and used correctly, it will definitely not work effectively. Since that's the case, let's take a look at the instructions for using the Jiehe tube together.
When installing the crane tube, it is necessary to follow the corresponding standards. Special attention should be paid to the connection between the oil distribution platform and the crane tube, ensuring that the connection between the oil distribution platform and the crane tube is secure.
When installing the crane pipe, it is necessary to connect the horizontal short pipe to the foundation flange on the oil distribution platform. Next, connect the horizontal short pipe and the lifting arm. Once these tasks are ready, you can start installing the balancer and then connect the tension rod of the balancer.
When installing the crane tube, it is necessary to focus on adjusting the balancer within the specified range.
When installing the crane tube, it is also necessary to pay attention to cleaning each flange surface to avoid other substances affecting the installation of the crane tube. If there is a sealing groove, it is best to install the O-ring before connecting it.
How to use the crane tube? There are generally the following precautions
1. The entire operation process of the crane tube ensures that the safety limit alarm system is sensitive and easy to use.
2. Before each loading and unloading operation, check whether each system is normal.
3. Strictly follow the manual operation procedures of the loading and unloading arm (crane tube).
4. When operating the outer arm, do not use excessive force, and should use even force.
When assembling the crane tube (fluid loading and unloading arm), it should refer to the working diagram, install from the base rotator to the vertical aluminum tube, from bottom to top, and finally install the balancer.
6. Do not use the balancing device as the force position during operation.
When adjusting the balance force, place the fuel injector in a horizontal position and unscrew the end cap at the tail end of the balancer to see the adjustment screw. If the crane pipe has a free downward trend, tighten the screw with a socket wrench. If the crane pipe has a natural upward trend, loosen the screw until the crane pipe oil arm can stop stably within the range of -5 ° to 60 °.
When the interface of the loading and unloading crane pipe is connected to the tank car, it is not allowed to open the valve of the loading and unloading pipe.
9. Please do not start the loading and unloading system, especially the valve of the loading and unloading pipe assembly, without understanding the working principle and operating steps of the loading and unloading arm (fluid loading and unloading arm).
The above is the correct use and installation of the crane tube, hoping to be helpful to you.